Laundry Centers - After I press the start button, when will water fill the tub?
Applies to
- Laundry Centers
Solution
With Frigidaire High Efficiency Laundry Centers, the first 2 minutes of the cycle are spent sensing the size of a load.
The water level, agitation intensity and vibration tuning are set based on the load size that is detected. Water will enter the tub once the sensory cycle is complete.
Was this article helpful?
Related Articles
- Why does my Frigidaire Laundry Center beep or have blinking lights?
- What should I do if my Frigidaire Laundry Center is not properly heating or drying?
- Is it normal for my Frigidaire Laundry Center to make sounds or noises?
- Laundry Centers - Why does the water level seem low in my Laundry Center Washer?
- Laundry Centers - How can I reduce the Wash cycle time?
- Why did my Laundry Center stop during a cycle and give three long beeps?
- What should I do if my Frigidaire Laundry Center is not starting?
- Laundry Centers - How long is the wash cycle on my Laundry Center?
- What should I do if the washer on my Laundry Center Washer is not spinning?
- Laundry Centers - How do I avoid Out-Of-Balance problems during the spin cycle?
Related Articles
- Why does my Frigidaire Laundry Center beep or have blinking lights?
- What should I do if my Frigidaire Laundry Center is not properly heating or drying?
- Is it normal for my Frigidaire Laundry Center to make sounds or noises?
- Laundry Centers - Why does the water level seem low in my Laundry Center Washer?
- Laundry Centers - How can I reduce the Wash cycle time?
- Why did my Laundry Center stop during a cycle and give three long beeps?
- What should I do if my Frigidaire Laundry Center is not starting?
- Laundry Centers - How long is the wash cycle on my Laundry Center?
- What should I do if the washer on my Laundry Center Washer is not spinning?
- Laundry Centers - How do I avoid Out-Of-Balance problems during the spin cycle?