Refrigerators - Error Codes and Alarms Guide
Issue
- Refrigerator Error Code and Alarms Guide
Applies to
- Refrigerators
Solution
How to reset/clear Error Codes
- Depending on upon which model your unit is, you may try one of the following:
- Pressing "“CLEAR ALERTS" button on the unit.
- Reset the unit by unplugging the unit for 30 seconds and plugging it back in.
- If you are unable to unplug the unit, you can try flipping the breaker at the fuse box, please note that this will reset everything on same circuit.
- For more information please refer to your use and care guide.
SB SB - Sabbath Mode
Sabbath Mode is designed to make the appliance function with minimum power to conform with religious guidelines. For more information, refer to Refrigerators SB SB Error Code - Sabbath Mode.
77 77 - Demo Mode
Demo Mode is designed for the display set up in the store without using the functional components. For more information, please refer to your use and care guide.
DI SP (or DISP) - Ice Jam (Audible Tone)
Indicates there is ice jammed in the shoot. An alarm will sound when a cube is stuck in the shoot too long. For more information, refer to Refrigerators DI SP or DISP Error Code - Ice Jam.
PF or Power Failure Light - Power Outage
Indication of power outage or power surge. This could result in a high temp alarm as well. For more information, refer to Refrigerators PF Error Code - Power Outage.
H or HI (Blinking Temp & Audible Tone) - High Temp
HI blinking on the refrigerator temp indicates the temperature is too high in the refrigerator or freezer for over one hour. Usually activated when door is left open too long. For more information, refer to Refrigerators H or HI Error Code - High Temp.
Door Ajar - Door Left Open (Audible Tone)
Door has been left open for over 5 minutes.
Beeping and Display Lights Up
This could be an indication of the power failure or error. Try to hard reset the unit by unplugging it for 2-3 minutes and plugging it back in.
IF YOU WERE UNABLE TO RESOLVE YOUR ISSUE
- For units installed within the past 30 days, please refer back to your installer to resolve this issue.
- For units installed after 30 days please contact us to schedule service.