Oven Error Codes and Alarms Guide

Issue

• Oven is displaying an error code

Solution

How to reset/clear Error Codes

• Reset the unit by unplugging the unit for 30 seconds and plugging it back in.
• If you are unable to unplug the unit, you can try flipping the breaker at the fuse box, please note that this will reset everything on same circuit.
• For more information, please refer to your use and care guide.

F10 – Thermal Runaway

• Stone-Baked Pizza Ovens
  F10 could be the result of the Pizza Shield being on the incorrect rack position.
  • Please confirm that your oven rack and Pizza Shield is in rack position 7. Some models may vary for more information, please refer to your Use and Care Guide.
  • After confirming the position of the Pizza Shield, reset the unit and begin the Stone-Baked Pizza preheat again.
    
• Standard Range Ovens and Wall Ovens
  F10 indicates your oven is detecting higher-than-normal temperatures. This is a built-in safety alert to help protect the appliance and ensure safe operation.
  • Please turn off your oven and allow it to cool down before using it again.
    
• If the issue persists, contact us for support.

F30 – Open Probe

• Please try to reset the unit by unplugging the unit for 30 seconds and plugging it back in.
• If you are unable to unplug the unit, you can try flipping the breaker at the fuse box, please note that this will reset everything on same circuit.

F90, F91, F92, F93, F94 – Door Lock Issue

• To unlock the oven door, press the UNLOCK key, Once the controls and door are locked, there is no access to any cooking functions.
• To unlock the oven door and control, press UNLOCK and follow directions on the screen. You will be shown a code to use for unlocking the doors and controls.
• Please try reset the range by disconnecting the power to the unit for up to 30 seconds. This will clear most false error codes. You can disconnect power by either unplugging the unit or flipping the circuit breaker off and back on.

DEMO MODE – Unit is in Demo Mode

• Turn oven off at circuit breaker
• Wait 45 seconds
• Turn circuit breaker back on
• Go to settings menu on oven
• Scroll to demo mode and select/turn off